From: andyandlynn on 6 Jul 2008 19:39 I have a 96 Subaru Legacy. Occasionally, when starting, I turn the key, the dash warning lights come on (lamp check function, I guess) but the starter doesn't turn. Then, if I press in on the key or push up on it while turning, the starter cranks just fine and the car starts. I'm thinking the ignition switch is getting old (the car has 104K miles and it is 12 years old). Is that a hard thing to replace? TIA Andy
From: MasterBlaster on 7 Jul 2008 03:31 <andyandlynn(a)mycomspan.com> wrote: > I have a 96 Subaru Legacy. Occasionally, when starting, I turn the > key, the dash warning lights come on (lamp check function, I guess) > but the starter doesn't turn. > > Then, if I press in on the key or push up on it while turning, the > starter cranks just fine and the car starts. > > I'm thinking the ignition switch is getting old (the car has 104K > miles and it is 12 years old). > > Is that a hard thing to replace? According to Autozone's online repair guide... Ignition Switch Subaru Coupes/Sedans/Wagons 1985-1996 Repair Guide Legacy and Impreza The ignition switch is mounted in place using special shear bolts. Removal of the ignition switch requires replacement of these bolts. When removing the bolts it is easiest if you use a suitable punch and hammer to tap the bolts around. When installing new bolts tighten the bolts until the shear heads break off. 1 - Disconnect the negative battery cable. 2 - Remove the upper and lower steering column covers. 3 - Disconnect the ignition switch harness from the body harness. 4 - Using a drift and hammer, hit the heads of the shear bolts to loosen and remove the ignition switch mounting bolts. To install: 1 - Install the ignition switch with new mounting bolts. Tighten the mounting bolts until the bolt heads snap off. 2 - Connect the ignition switch electrical harness. 3 - Install the steering column covers. 4 - Connect the negative battery cable.
From: andyandlynn on 13 Jul 2008 00:39 Thanks to both of you for the input. I went to a local garage and the guy there verified what you said. It's about a $300 job to do the column switch. He also said it might be the contacts on the starter solenoid which I guess is a pretty common problem. And a bit cheaper. And, of course, since then, the car has started perfectly. I have to listen the next time it doesn't start to see if I hear a "click" which would indicate solenoid problems. Thanks again. Andy
|
Pages: 1 Prev: Repair Manual For 1994 GMC Sierra 1500 Next: Battery group size codes? |