From: Harry Face on 27 Feb 2010 00:52 Nate, My 73 Impala's front license plate bracket ended and inch past the four bolt holes, and the plate got bent around everytime it went through a car wash. Eventually I had a three piece front license plate screwed down to a piece of wood which was then fastened to the license plate mounting bracket. The car wash never wrecked the plate again.. My mothers 1991 Cadillac front License plate is screwed to a backing plate that slides down over two round protrusions in the center of the front bumper. If you give the plate a bumpe upward it comes right off. She lost it once while parking - the front bumper rode up some plowed up snow. I found it later at the restaurant when I noticed it missing. Forget using those license plate frames. They also block the view of the registration decal if you have one on the rear plate. Good Luck harryface 91 Bonneville 321,654 05 Park Avenue 95,001
First
|
Prev
|
Pages: 1 2 Prev: Advice Needed: Aerostar AC Compressor Clutch Next: And now the Bull starts |